Integration manual, revision 1.0, for connecting, configuring, operating and validating Advisor Advanced / ATS Advanced with System C4 using the Advisor Advanced driver with FWK4. Covers ATSx500A(IP) panels, DGP and RAS devices, CDC4 standard and extended modes, Ethernet communication and encryption, device configuration and configuration retrieval, PIN/card credentials, synchronization and profiles, time restrictions and holidays, door and lift control, intrusion alarms, status and audit-event mappings, recovery, upgrade limitations and troubleshooting. The documented supported firmware range is MR_4.7 to MR_4.13; earlier MR versions appear only in explicitly version-specific operating notes. Includes 35 integration test procedures with expected results, evidence and execution-record requirements; it does not record a completed test run or certify an installation.
Integration manual for connecting the ASSA ABLOY SC-1000 system to System C4 using the FWK4 driver, covering access control and intrusion alarm functionality in document revision v1.2. Describes MQTT over TLS connectivity, controller and certificate configuration, device-tree import, supported cards and combined Card and PIN credentials, credential synchronization, access-time restrictions, holidays, time management, lift functionality, remote commands, status information and device audit-log retrieval. Includes integration limitations, troubleshooting guidance and integration tests with steps and expected results for configuration, communication failures, credential uploads, access events, doors, partitions, detectors and relay outputs.
Integration manual for connecting MB-Secure panels and ACS PRO access panels to System C4 through the MB Secure driver for C4 FWK4. Describes the independent IQ Multi Access SDK channel for person and credential management and the secure ISOM WebSocket channel for panel monitoring and control, including compatibility, licensing prerequisites, device configuration, OPIF import and addressing, credential synchronization, profiles, time management, and integration restrictions. Includes remote-control, status and audit-log references, recovery and maintenance guidance, migration to C4 Transformers, troubleshooting, and integration tests with procedures and expected results.
